The MG10 hammerhead flash unit from manufacturer Nissin will be available from the end of this month priced $599. The handle-mount flash is designed to be used both attached to the camera and as a studio-type head, and has a maximum guide number of 262ft/80m@ ISO 100 and with the zoom set to the 200mm position.
When connected to the camera via the company’s 2.4Ghz Nissin Air System radio communication the flash can be remotely triggered and controlled, and the zoom head will automatically synchronize with the focal length of the lens in use. The head can adjust to cover focal lengths of between 24mm and 200mm, while an additional diffuser panel expands the coverage to 18mm. Using the Air system the flash unit can be used to trigger the camera too, as it has a shutter release button built-in to its grip.
The handle can be mounted on the left or the right side of the camera, and is powered by either eight AA cells or a pair of rechargeable PS8 lithium ion batteries. When the Li-ion batteries are in use recycling time drops from 3.5 seconds to just 1.5 seconds at full power, and we should expect 500 full power bursts per charge.
A modeling light is included to assist pre-visualization, and every unit comes with a quick release L mounting bracket, AA magazine, a ball head and a filter holder. Via the Nissin Air System the MG10 can wirelessly operate with up to eight groups of other flashes in TTL and M modes, and a MicroSD card slot is designed to allow users to update firmware themselves when improvements are released.
The ultimate power – Nissin MG10
An advance NAS 2.4Ghz Wireless strobe for on-camera and studio shoot
Nissin Japan Limited (Chairman Mr. Goto Chikara) proudly announces the MG10, an advance NAS (Nissin Air System) 2.4Ghz Wireless strobe for both on-camera and studio shoot, available in the bottom of Jun 2018
The MG10 is a high power (80GN, 165 w/s) advance strobe in the N.A.S., Nissin Air System*1. The flexible hand grip arrangement which can be used both left and right side with height level adjustment. Every single MG10 included a quick release mounting magnesium “L” bracket, AA battery magazine, Li-Ion battery magazine, ball head, filter holder and wide-angle diffuser. There is a shutter release button on top of the handle and standard adapter screw under the flash head for using in the studio shooting. It also fully supports Air 10s and Air 1 commander wirelessly.
Patented design – magnetically contacted motorized zoom head *2
The removable external motorized zoom allows MG10 to zoom 24 ~ 200mm and 18mm with diffuser. It can also control in manual and auto synchronize lens focal length via Air 10s.
Fast recycling time with full power
When two Li-ion batteries with PS8, type 26650, the recycling time is only 1.5 seconds (500 flashes with 5000mAh batteries or higher). With 8 AA re-chargeable batteries the recycle time is approximately 3.5 seconds*3.
High power modelling light (LED)
The powerful modelling light without zoom head which is perfect match for applying to the studio usage.
Set your group of strobes free – The Open Mode allowing multiple Air10s pair to the same group of strobes
The “open mode” allows for multiple Air10s units to pair the same group of the MG10 strobes which means the need to re-pair devices is eliminated. Even if cameras are changed, the same settings can be used as the shoot continues. This convenient functionality allows multiple cameras and commanders to share a same group of NAS strobes (MG10).
New wireless remote shutter replaces the camera shutter button
With the wireless remote button from flash, signal can transfer through the shutter cable socket (2.5mm) on Air 10s and then go to the camera. It is more flexible for holding MG10 as shutter release to moving around during shooting.
Independent control of maximum 8 groups
MG10 supports the basic and advance groups in maximum 8 groups via Air 10s. The basic group which is independently control the exposure setting in TTL or M mode. The advance group which is control both TTL and M mode in the mixing setting.
Sustainable performance – easily updated via a Micro SD card slot
The MG10 equipped with a Micro SD card slot that allows user to update the device easily by themselves. Nissin plans on putting a Micro SD card slot on all future strobes and commanders.